Pole & Pylon Sign Engineering

Engineering for single-pole and two-pole pylon signs: pipe or square tube size, drilled shaft or spread footing design, base plate and anchor rods, wind loads at your address. Signed and sealed for permit in FL, AL and TX.

Start an order

Sealed Plans and Foundation Design

A pole sign plan has to show the reviewer that the pole and its foundation resist the wind at that address. Enter the sign width, height and clearance, and the design sizes the steel pipe or square tube, the foundation and the connections.

Foundations can be a drilled shaft with the pole embedded, a spread footing with a base plate and anchor rods, a reinforced pier, or a pad on a drilled shaft where deep drilling is a problem. The order form only offers the options that work at your site.

Tall signs can use a spliced pole with a sleeve or flange connection. Two-pole signs get separate or combined footings depending on the spacing.

What's covered

  • Wind load per ASCE 7 at the job address
  • Pole flexure, shear and torsion checks with ratios
  • Foundation depth, footing size, rebar and concrete called out on the detail

How it works

  1. Enter the job address. We look up the wind speed and flood zone there.
  2. Enter the sign type and size. The form shows only the options that meet code at that address, and the flat price.
  3. Pay online. A licensed engineer reviews, signs and seals the plan in 48 to 72 hours, or the same day with rush.

Licensed in Florida (PE 82229), Alabama (PE 36987) and Texas (PE 133174, Firm F-22869).

Sample signed and sealed sign engineering plan sheet with elevation, foundation detail and structural calculations

Order sealed sign plans